Laser 28 International Class Association Homepage
Forum Home Forum Home > Laser 28 General > Maintenance
  New Posts New Posts RSS Feed - Cutting tool
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Cutting tool

 Post Reply Post Reply
Author
Message
Hoodoo View Drop Down
Crew
Crew
Avatar

Joined: 27 February 2008
Location: Canada
Status: Offline
Points: 30
Post Options Post Options   Thanks (0) Thanks(0)   Quote Hoodoo Quote  Post ReplyReply Direct Link To This Post Topic: Cutting tool
    Posted: 25 October 2011 at 8:34pm
I want to cut a hole in my port forward cockpit seat to install a Lewmar portlight range. Wich tool should I use? Does kevlar needs specific attention? Thanks
Back to Top
Bill Layton View Drop Down
Commodore
Commodore
Avatar

Joined: 15 September 2002
Location: Canada
Status: Offline
Points: 551
Post Options Post Options   Thanks (0) Thanks(0)   Quote Bill Layton Quote  Post ReplyReply Direct Link To This Post Posted: 25 October 2011 at 9:14pm
at the factory we used standard holesaws for the corners and diamond jigsaw blades for the straights
Back to Top
Jon167 View Drop Down
Skipper
Skipper
Avatar

Joined: 14 April 2011
Location: Webster NY
Status: Offline
Points: 95
Post Options Post Options   Thanks (0) Thanks(0)   Quote Jon167 Quote  Post ReplyReply Direct Link To This Post Posted: 25 October 2011 at 9:16pm
roto-zip with a spiral bit will work fine. go real slow or use a hard template.....
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.03
Copyright ©2001-2015 Web Wiz Ltd.

This page was generated in 0.469 seconds.