Laser 28 International Class Association Homepage
Forum Home Forum Home > Laser 28 General > Maintenance
  New Posts New Posts RSS Feed - Forward hatch gasket replacement
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Forward hatch gasket replacement

 Post Reply Post Reply
lucgmix View Drop Down

Joined: 30 June 2007
Status: Offline
Points: 43
Post Options Post Options   Thanks (0) Thanks(0)   Quote lucgmix Quote  Post ReplyReply Direct Link To This Post Topic: Forward hatch gasket replacement
    Posted: 03 April 2010 at 12:36pm
Taylor Made Products
Part # 1725
Hatch gasket 1/2" x 7' with self adhesive strip
Look in Hatches & Windshield Accessories, then look in Hatch replacement parts and you will find it there.

You must clean up old gasket surface really well first.

Now this isn't the original gasket we used but it’s the closest one available and it works real good.... Its a bit bigger but compresses nicely into the frame. Actually this is better than the original gasket we used. Remember during installation not to cut the gasket to the correct length until you are ready to glue the two ends together.

Start by sticking the gasket down in the aft middle part of the frame, and then continue sticking it around the frame allowing plenty of room for the gasket to bend in the corners. When you end up where you started, cut the excess off but leave it a centimeter too long and then crazy glue the two ends together. Take your time and think it through... It will turn out perfect!

Edited by lucgmix - 03 April 2010 at 12:37pm
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.03
Copyright ©2001-2015 Web Wiz Ltd.

This page was generated in 1.422 seconds.