Bent Turnbuckle

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   During mast raising yesterday, we somehow bent the lower turnbuckle housing of the rear shroud. The piece that attaches to the chain plate. We also bent the joining rod. 

Could you tell me how to find a replacement? 

Thanks so much, john

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
fatjohnz Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 05 August 2006 Location: United States Status: Offline Points: 304	Post Options Post Reply Quote fatjohnz Report Post Thanks(0) Quote Reply Topic: Bent Turnbuckle Posted: 26 April 2013 at 8:01am
	During mast raising yesterday, we somehow bent the lower turnbuckle housing of the rear shroud. The piece that attaches to the chain plate. We also bent the joining rod. Could you tell me how to find a replacement? Thanks so much, john

Bill Layton Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 15 September 2002 Location: Canada Status: Offline Points: 551	Post Options Post Reply Quote Bill Layton Report Post Thanks(0) Quote Reply Posted: 26 April 2013 at 8:27am
	Those are Navtec rigging parts, all are 3/8" thread Bottom EYE part # D541-1212 Threaded Stud # D320-S12 Anyone who sells Navtec rigging should have it. Goodluck!

fatjohnz Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 05 August 2006 Location: United States Status: Offline Points: 304	Post Options Post Reply Quote fatjohnz Report Post Thanks(0) Quote Reply Posted: 28 April 2013 at 9:49am
	Hi Bill, Do you have the P/N for the turnbuckle/screw that attaches to the chainplate? In the quote that I got they noted that the EYE-end did not include the turnbuckle. Thanks, John

Bill Layton Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 15 September 2002 Location: Canada Status: Offline Points: 551	Post Options Post Reply Quote Bill Layton Report Post Thanks(0) Quote Reply Posted: 28 April 2013 at 10:14am
	There are only 3 parts to the navtech turnbuckle... the eye end is the part that attaches to the chainplate (it can get bent), the other parts are the threaded screw (can get bent too) and the part that is swaged onto the shroud (never gets bent) Look at this page here http://pdf.nauticexpo.com/pdf/navtec/navtec-general-catalog/21929-29204-_42.html and note the eye end and turnbuckle screw, this is what you have. The threaded stud part number listed above is the turnbuckle screw. I have ordered these part numbers before and rec'd the correct parts, unless they have changed part numbers. Edited by Bill Layton - 28 April 2013 at 10:17am

fatjohnz Members Profile Send Private Message Find Members Posts Add to Buddy List Commodore Joined: 05 August 2006 Location: United States Status: Offline Points: 304	Post Options Post Reply Quote fatjohnz Report Post Thanks(0) Quote Reply Posted: 28 April 2013 at 10:29pm
	Thanks Bill, you're right. I had the boat in front of me this afternoon and it was clear as you describe. Thank you, john