|
Hull Repair |
Post Reply 
|
| Author | |
unnamed 
Rookie 
Joined: 11 August 2011 Location: montana Status: Offline Points: 15 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Hull RepairPosted: 26 February 2012 at 8:45pm |
|
Thanks for the confirmation. Now if only Spring would hurry up.
|
|
 |
|
|
Bill Layton
Commodore 
Joined: 15 September 2002 Location: Canada Status: Offline Points: 551 |
Post Options
Thanks(0)
Quote Reply
Posted: 26 February 2012 at 9:13am |
|
West system is fine. Using a hole saw is what was used at the factory for drilling the thru-hull holes thru kevlar or glass hulls :)
|
|
|
|
|
unnamed
Rookie
Joined: 11 August 2011 Location: montana Status: Offline Points: 15 |
Post Options
Thanks(0)
Quote Reply
Posted: 26 February 2012 at 3:50am |
|
I
am replacing my transducers and the new ones
are larger than the old ones. I used the West System before on a similar
project for a different boat, but wanted to see if there was any considerations
for dealing with the Kevlar Hull. I also need to repair a small gouge to the
bottom. Again I am thinking of using the West System.
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options