Laser 28 International Class Association Homepage
Forum Home Forum Home > Laser 28 General > Maintenance
  New Posts New Posts RSS Feed - Outhaul run path in boom
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Outhaul run path in boom

 Post Reply Post Reply
Author
Message
Ron Waterson View Drop Down
Commodore
Commodore
Avatar

Joined: 21 October 2014
Location: Rivals, KY
Status: Offline
Points: 118
Post Options Post Options   Thanks (0) Thanks(0)   Quote Ron Waterson Quote  Post ReplyReply Direct Link To This Post Topic: Outhaul run path in boom
    Posted: 23 August 2018 at 7:28pm
Exposed line on outhaul let go last night while racing.  In boom wire it was attached to seems fine, just need some idea how to get a new line reattached to the wire, in to the boom where the inset block attaches to the bottom of the boom.  I'm guessing I need to take the aft boom cap off an do some fishing, but does anyone know how the wire runs inside the boom?   

  Ron  
Hull 147 - Angel's Share
Back to Top
Bill Layton View Drop Down
Commodore
Commodore
Avatar

Joined: 15 September 2002
Location: Canada
Status: Offline
Points: 551
Post Options Post Options   Thanks (0) Thanks(0)   Quote Bill Layton Quote  Post ReplyReply Direct Link To This Post Posted: 23 August 2018 at 9:23pm
That is correct Ron, you need to remove the end cap on the end of the boom and you will then have access to that wire end. You'll have to remove the front cap as well as that will show you how the 2:1 rope system was attached. It all makes sense once it's apart. 

Sometimes the block that is swaged onto the wire end needs to be replaced. You'll understand once it's all apart.


Edited by Bill Layton - 23 August 2018 at 10:12pm
Back to Top
Ron Waterson View Drop Down
Commodore
Commodore
Avatar

Joined: 21 October 2014
Location: Rivals, KY
Status: Offline
Points: 118
Post Options Post Options   Thanks (0) Thanks(0)   Quote Ron Waterson Quote  Post ReplyReply Direct Link To This Post Posted: 23 August 2018 at 10:03pm
Ahhh 2-1.  OK.  Fun fun fun, drilling rivets out and fishing around in the boom.

Thanks for the info Bill,

   Ron
Hull 147 - Angel's Share
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.03
Copyright ©2001-2015 Web Wiz Ltd.

This page was generated in 0.625 seconds.